PiRelay - Raspberry Pi GPIO

The app is superb and perfectly serves my desire of multiple R-Pi mode. Suggestions: 1) Add a slider so that it can be used with light dimmers or fan regulators. There is an immense need of this feature. 2) Increase the number of R-Pi from 5 to 10/15 l, this can really serve a big home automation. I currently used this app to configure a complete home with 5 R-Pi with no switches installed. Facing problem with Fan regulator. So please add slider at your earliest.

Works as expected, it would be best if https and some kind of authentication can be added. Great work, light and simple, just what you need.

Gr8 app. Is there away to change the "relay icons". They are a little limited. I use fans and pumps. Keep up the good work.

Works great especially with your raspbian build. Only issue is (with the build) that I can't seem to VNC into my pi which I can when I use the official raspbian build. "Connection refused"

Nice new update but please add the ability to change the on/off icon it now changes from blue to green and has no on/off on the icon anymore. Also a timer function would be excellent!

Love the update, I can now control all of my pis from the app!

I paid for the v1 app then it got automatically updated on my phone and now I have to pay for it again or it will stop working. Feel a bit extorted...

I hope this guy keeps updating this app. After the many I have tried this one is the best so far, it looks great and is really simple and clean.... Keep up the great work.

Got it working on RPi 3 with a 4 channel relay. Thanks for the app.

I had problems with what pins were what gpio's as well my relay always was activated. Turns out I was feeding it 5v and the relay board only needs 3.5. Once I switched down to 3.5 v feed from raspberry pi to power relay board it started working perfectly. Gpio pin outs are confusing on the pi

It's working perfectly, I can't change ports. If I change listen port 80 and virtual host 80 the software not communicate some country port 80 is block can u help me how to change ports, bcoz I want to port forwarding to external ip address

good aplication all works corectly,i just need more gpio,for raspbery pi 2 B is have more 20gpio

Works like a charm! Just wish i could add another 8 relays and control them as well..

Great app! got my PiFace project up and running very quickly and easily from the manual install instructions. A+++ Question though, does/will your app support ipv6?

remote start on my car using this app the pi and 4ch relay board ....boot up pi and instantly pirelay is operational ulike webiopi setup I once had .thanks dev for your work ..its very much appreciated by all hackers and diy tinkers.. ps I would donate a lump sum if I were able to use this with my samsung gear s watch !!!!!

Super app

Works great, is there any way you could add a password option, so I could use it away from home?

would be great if add more profile in it as I got four raspberry pi gotta change ip everytime.. e.g xbmc app do have a profile for each room..

Quick respond to problem work excellent now. Thank you.

Great little app for controlling relays or any logic level inputs via the raspberry pi's i/o port. Icing on the cake would be if you could monitor a few inputs as well as control some outputs. Well worth the money though.